chat_core_ensure_channel_ready() had a duplicate CREATE TABLE peers_*
with OLD schema (no node_RTT, node_type, connected). Since it was called
from 4 places WITHOUT topo_node_sqlite_channel_put() first, the old
schema was created first, and IF NOT EXISTS in the new DDL was a no-op.
Removed the entire old block. Only topo_node_sqlite_channel_put() now
creates peers_* tables with the full schema.
Also removed ORDER BY p.node_RTT from get_public_peers/get_local_peers —
ordering not needed for sequential connect attempts.
Добавлено:
- conn_mgr_connect_from_invite() — подключение к новому узлу по invite-данным
(INIT → INVITE_INFO_REQ/RESP → проверка членства в группе → сохранение в БД)
- topo_group_connect.c — авто-подключение при старте CHAT-группы:
Phase 1: одновременный connect всех connected=1 пиров, таймаут, отмена незавершённых
Phase 2: последовательный перебор публичных адресов до первого успеха
- Счётчик active_conn_count с проверкой nodeinfo-путей (UP/DOWN)
- restart() при phase=DONE и count==0
БД:
- connected INTEGER NOT NULL DEFAULT 0 в peers_<ch> + ALTER TABLE для существующих
- topo_node_sqlite_set_connected / get_connected_peers / get_public_peers
Chatgui:
- Включён topo_group (убран utun_instance_set_topo_group_enabled(0))
- Создание TOPO_GROUP_TYPE_CHAT при channel_ready и при старте
- Invite connect через conn_mgr_connect_from_invite
- Удалён chat_conn_mgr (из сборки) + весь старый auto-connect код
- etcp_router: SVC_ROUTE_HDR (+8B), ETCP_ROUTER_CONN/TRANSIT_QUEUE хеши расширены под group_id
- Все caller'ы (proxy, routing, conn_mgr, nat, chatgui, tests) обновлены
- topo_group: глобальный реестр TOPO_NODE по node_id, ref_count=0 при создании
- BGP-обмен активируется для всех групп (а не только дефолтной)
- Протокол: group_id добавлен в WITHDRAW/TABLE_REQ/TABLE_COMPLETE/ERR_GROUP_MISMATCH
- Per-connection коллбэки заменены на instance-level conn_status
- msg_transport полностью удалён из проекта
57/57 тестов
- topo_node_sqlite_member_put: remove joined_at column from INSERT (not in server schema, duplicates join_ts)
- chat_core: rename peers table column name→userinfo to match server schema + add ALTER TABLE migration
- chat_sync: remove 3 redundant INSERT INTO nodes that wrote raw JSON userinfo into nodes.name, overwriting correct plain name from topo_node_sqlite_node_update_verified
- config_updater.{h,cpp}: single implementation — config_update_in_lines
for batch updates + config_update_option for file-level. REPLACE/APPEND
modes, section auto-creation
- node_config.cpp: generateIdentity() now derives node_id via
SHA256(pubkey) (like sc_derive_node_id_from_pubkey) instead of random.
save() uses config_update_in_lines for line-level update when file
exists, saveFull() only for new file and addServer/addClient.
Removed duplicate findSectionBounds/updateOptionInSection/configUpdateOption
- test_config_updater.cpp: Q_ASSERT replaced with VERIFY macro — Q_ASSERT
in Release mode does not evaluate the expression, causing false positives.
Test now works in both Debug and Release
- Remove is_dm column from channels table (dm detection by member count)
- Rename member name column to userinfo — extensible json_flat format
- Add json_flat.c/h library for compact JSON serialization
- Fix join_sig message format: use ch_x25519+ch_ed25519 instead of channel_id string
- Remove name from join_msg body (now in userinfo via json_flat)
- Update chat_core, chat_sync, member_sync, db_manager to new format
- Add topo_strategy.txt — архитектурные заметки по топологии
- chat_conn_mgr.c/h: new connection manager (1 per instance, global in g_cc)
- cm_rotation() — single rotation method: random addr pick, INIT, retry
- 10 parallel slots per node (CM_MAX_PARALLEL), evict worst RTT on excess
- DEAD slot reuse before close — close only when replacement ready
- per-connection DOWN callback via etcp_conn_add_down_cbk
- background ping cycle: random node→random addr RTT measurement
- chat_core.c: added g_cc.conn_mgr field, init/destroy/getter
- chat_sync.c: migrate to new API, add_node() at WELCOME/JOIN/PEER_UPSERT
- Removed old ca_state/ca_ctx/ca_* single-flight code
- Sound files loaded from filesystem (sound_dir in INI config, absolute or relative)
- Per-event enable/disable + volume stored in DB (ui_state table)
- SoundManager: setEvent(), effective volume = master * per-event
- SoundSettingsPage UI: 4 event rows (checkbox + slider)
- chat_core_save_ui_state() for async DB writes via uasync thread
- DbManager::getUiStateInt() for reading settings from GUI thread
- Default sounds copied to sounds/ dir next to DB, config entries written
INSERT OR REPLACE deletes the old row and inserts a new one,
resetting unspecified columns (online, update_ts) to DEFAULT 0.
This was wiping online=1 set by cs_on_peer_status_changed/member_sync_set_online.
Replaced 5 INSERT OR REPLACE INTO nodes with INSERT INTO ... ON CONFLICT
DO UPDATE SET — only updates the specified columns, preserving online status.
Files:
- chat_core.c:638 (invite flow)
- chat_sync.c:1045 (CHANNEL_INFO_RESP), 1193 (JOIN), 1449 (PEER_UPSERT)
- topo_node_sqlite.c:121 (BGP node_put)
- cs_handle_channel_join: call cs_post_channel_online immediately after adding joiner
- member_sync_start with _on_invite_sync_done callback: on MT_OK push online=1 via merkle_sync_push_update
- DEBUG per-peer online status in cs_post_channel_online
- cs_on_conn_up: call cs_on_peer_status_changed(peer,1) before return
in invite path (was skipped, leaving inviter at online=0 in DB)
- cs_handle_welcome: remove unconditional set_online(0) — online
status is managed by conn_up/conn_down, not by WELCOME
- cs_handle_welcome: add cs_post_channel_online() after WELCOME
to send PEERS_ONLINE to GUI when channel is fully loaded
- cs_post_channel_online: add DEBUG log for PEERS_ONLINE event
- db_sync peer_check: suppress spam log when no peers connected
- chat_core_sync_my_addresses: DELETE + INSERT с подсчётом строк, CHECK verify
- chat_core_connect_from_invite: DELETE + INSERT с IP:port
- member_sync_put: DELETE + INSERT с IP:port, warn если addrs_data=NULL
- cs_handle_channel_info_resp: адрес инвайтера из ETCP link
- cs_handle_channel_join: адреса джойнера
- cs_handle_peer_upsert: адреса пира
- cs_handle_welcome: адреса из WELCOME
Все логи с префиксом [ADDR_SYNC] в DEBUG_CATEGORY_DEBUG
- mainwindow.cpp: swap setupMessaging() before setupNode() so g_receiver is created first
- gui_bridge_impl.cpp: add DEBUG_WARN when gui_bridge_post drops event due to NULL g_receiver
- utun_node.cpp: open topo_sqlite_db with FULLMUTEX + all PRAGMAs (WAL, FK, NORMAL sync, checkpoint)
- db_sync.c: reuse inst->topo_sqlite_db if available (shared_db flag)
- chat_core.c: reuse inst->topo_sqlite_db if available (shared_db flag)
- db_sync_destroy/chat_core_destroy: skip close on shared handle
- Only topo_groups_destroy closes the shared handle
- Fallback: each module opens own connection if topo_sqlite_db is NULL
ready_cbks/etcp_conn_set_ready_cbk/add_ready/remove_ready → init_cbks/..._init_cbk
ca_ready_cb → ca_init_cb
cm_direct_ready_cb → cm_direct_init_cb
cm_reverse_ready_cb → cm_reverse_init_cb
ntp_node_on_conn_ready → ntp_node_on_conn_init
connect_ready_cb → connect_init_cb
init accurately describes when conn->initialized=1, before keepalives establish UP.
Also fire etcp_fire_conn_status INIT at this point instead of create time.
- chat_core.c: dump node_addresses total, per-node counts, nodes lookup before addr query
- topo_group.c: log db path, rc, and db pointer after sqlite3_open
- topo_group.c: open {db_path}/chats.db instead of {db_path} — was opening a directory
- chat_core.c: remove inst->topo_sqlite_db = g_cc.db — keep topo_sqlite_db as separate
uTun-only connection without FULLMUTEX, avoiding contention with GUI reads
- chat_core.c: add DEBUG_INFO before each synchronous cb(FAIL) — pinpoints exact failure reason
- chat_sync.c: add log in ac_fill when ca_state=NULL after chat_core_connect_auto call
- Add etcp_add_conn_status_cbk/remove/set — unified callback for all connections
- 4 statuses: NEW, UP, DOWN, DELETE — one subscription covers all connections
- Fire points in etcp.c: create→NEW, on_up→UP, on_down→DOWN, close→DELETE
- chat_sync.c: replace cs_on_new_conn+per-conn subs with cs_on_conn_status
- db_sync.c: same migration to instance-level callback
- cs_is_peer_online: use conn->links_up instead of link->link_status (was 0 during INIT handshake)
- db_sync: rename column author→node_id, open chats.db instead of sync file,
db_sync_instance_add takes table_name directly
- chat_core: remove CREATE TABLE msg_ch_*, remove on_db_sync_insert (74 lines),
remove fallback INSERT in submit_message, add minimal on_msg_inserted
for GUI notification only
- db_manager: update getMessages for new schema (parse JSON from data column),
fix ORDER BY to use author_signature instead of datahash,
update syncCursorNext to parse JSON
- si_register simplified: db_count from same table, no more msg vs sync gap
- chat_core_has_conn: search all connections (pending+ready) by peer_node_id
- chat_core_connect_from_invite: skip chat_core_connect_auto if already connected
- ca_timeout_cb: close timed-out connection to free socket link slot
+ cancel remaining timers + ca_cleanup on all-failed
- cs_handle_welcome(): add self to local peers_<ch_id> so
joiner sees own account in channel member list
- cs_on_conn_up(): post CHANNEL_PEERS_ONLINE after reconnect
so GUI shows connected status (was only posted on conn_down)
- etcp_loadbalancer: DEBUG_WARN -> DEBUG_DEBUG for no suitable
link: tmr:wait — normal shaper behavior, not a warning
- chat_core_sync_my_addresses(): remove private IP filter (192.168, 10.x, etc.)
so LAN addresses are stored for direct connections
- topo_node_sqlite_channel_peers_all(): include peers without addresses
in WELCOME message (was skipped entirely, causing empty peer list)
- chat_core_create_channel(): pass real local addresses to member_sync_put()
instead of NULL,0
- chat_core_init(): log number of channels loaded from DB on startup
Evgeny